
Most Nickel Alloy 20 tubing orders hinge on one short line on the drawing, tucked beside the OD, and plenty of buyers read it last.
Key Takeaways
- An engineer picks the tube form well before a buyer sees the requisition.
- Plenty of acid coolers get retubed with Nickel Alloy 20 tubing.
- A wall callout missing the word min usually earns a phone call.
- Drawn tube gets a question or two at receiving now and then.
The note on the drawing says SMLS in capital letters, right under the OD. Somebody in purchasing still asks if welded is okay, and honestly that’s a fair thing to ask. Nickel Alloy 20 tubing gets bought in more than one form, and each has its own reasons for ending up on a print.
If you open the Nickel Alloy 20 tubing page, the size chart grabs your eye first, a long grid of X marks starting at 1/16 inch OD. The forms get mentioned higher up, in one line that’s easy to scroll past. Seamless is listed there, and so is welded, both plain and drawn.
Reading the Form Note on a Drawing
Seeing SMLS Only: A print that says SMLS only is pretty clear, and nobody argues with it much. Engineers who write that have a code paragraph in mind, or an old leak somebody still talks about. Ask, and most will tell you which one. For Alloy 20, the spec beside that note is usually ASTM B729.
Getting Drawn Tube Approved: Welded tube starts as flat strip welded along one seam, and for Alloy 20 it falls under ASTM B468. Drawn tube gets pulled through a die over a mandrel, and the bead comes out flattened, the wall more even. Some prints accept it in place of seamless, with an engineer’s okay.
Looking at Pressure Numbers before Picking a Form
Running the Stress Numbers: Engineers run the allowable stress tables before a buyer sees a requisition. In a lot of those tables, welded product carries roughly 85 percent of the seamless figure, a joint factor thing. Nobody fusses much over that on a drain line. On high pressure exchangers the wall might go up a gauge.
Retubing an Old Acid Cooler: The planner pulls the bundle drawing and copies whatever form went in last time, which is fair enough on a sulfuric acid cooler that ran fine. Nickel Alloy 20 tubing has a long history in that kind of service. Nobody wants to be the one who changed it.
Matching the Inquiry to the Size Chart
Getting the Wall Callout Right: Here’s where most of the back and forth starts. An inquiry for 3/4 OD by .065 wall looks finished, but the spec allows average wall or minimum wall, and the two quote differently. Leave that word off and expect a call the next morning. A clean inquiry covers these:
- The alloy written as UNS N08020, so nobody guesses.
- OD and wall, copied straight off the print.
- Min or ave beside the wall number, which somehow gets left off the most.
- Whatever form the engineer signed off on, drawn included.
Finding Alloy 20 on the Chart: Alloy 20 gets its own column, squeezed in between C276 and 904L. Seamless and both welded forms are named in the paragraph above it. Matching an OD and wall against the X marks takes maybe a minute. Most buyers run down the column twice anyway, just to be sure.
Sending the Drawing with a Quote Request
A retube a few weeks out is a decent time to sort the form out, not the week before. Pull the print and check the form note and the wall, then send a quote request with the drawing attached. It doesn’t need to be anything fancy, just a short email with the print on it.